PinScore Pinball LED Display for Bally, Midway / Williams System 11C

PinScore LED Pinball Display for Bally, Midway / Williams System 11C

PinScore Part No.: PS-12502-P

This PinScore LED display system is a complete, drop-in replacement display system. The low-voltage, high-efficiency displays use only your game's 5-volt supply and will work on pinball machines with failed high voltage power supplies. With custom-engineered color-matched LED (light emitting diode) blocks, the displays retain the game’s factory look while adding features like adjustable brightness and self-test.

This kit contains everything needed to replace displays:

Features

- Plug & Play installation
- Adjustable brightness
- Low power consumption uses only 5 volt power and no high voltage
- Beautiful black matte finish
- Foam light shields prevent general illumination leakage glare
- Crisp alpha and numeric digits illuminate in original font and color
- 5 year warranty
- Assembled in USA
- RoHS compliant

Compatible Games:

- Bugs Bunny's Birthday Ball (Bally)
- Dr. Dude, not for use on WPC89 games (Bally)
- Elvira and the Party Monsters (Bally)
- Mousin' Around (Williams)
- Pool Sharks (Bally)
- Radical (Bally)
- The Bally Game Show (Midway)
- Transporter the Rescue (Williams)

Installation Instructions

1. Remove Old Displays. Unplug the AC power from your pinball machine. Remove game backglass. Unplug all glass displays, display board connecting cables and remove original display boards. You may re-use your existing ribbon cables.
2. Mount the new boards. Hand-tighten the screws so you may align the displays with the backglass windows before permanently securing the boards. If further alignment is necessary, you may adjust the insert panel door hinges and latch in the backbox.
3. Connect the cables. Observe correct polarity on all ribbon cables - the red striped wires on all ribbon cables go to PIN #1 (also labeled RED) on all boards.
4. Observe the position of the small jumper block on the 2 pin connector near the board center labeled LEFT or RIGHT . This indicates the side of the game on which the board is mounted.
5. Double-check all connections, plug in the machine, and turn the game on. The LED Display will light up. Pressing the diagnostic pushbutton labeled (SW1/DISPLAY TEST) on the Master Driver board will illuminate all segments of all displays. This indicates that all components of the PinScore System are operating correctly. Use the thumbwheel (Brightness Control) to set your preferred illumination level.