Eddy Sensor Board, universal
search
zum Vergrößern anklicken (Abbildung ähnlich)
  • Eddy Sensor Board, universal

Eddy Sensor Board, universal

54,90 €  *
19% MwSt. inkl., zzgl. Versandkosten
Sofort versandfertig, Lieferzeit ca. 1-3 Werktage
Menge
Auf Lager

64718

Einstellbares Eddy Sensor Replacement Board für verschiedene Flipper

Ref. Artikel Nr.: A-16922, A-18543-1, A-18543-2, A-19237

R1 = 0 Ohm für Einsatz im Twilight Zone
R1 = 4,7 kOhm für Verwendung als Sensor Board

Widerstände werden mitgeliefert!

Installation:

  1. Place the board in the location in the machine. Use a single screw to hold it in place while you test.
  2. Connect the 4-pin (switch matrix) and 2-pin (sensor) connectors.
  3. Turn the machine on.
  4. Using a small screwdriver, turn the pot from end to end. It will rotate through about 3/4 of a turn.
  5. At one end, the LED will go on. When that happens, slowly turn the pot the in the opposite direction until the LED goes off.
    If the LED does not go off, your sensor or its wiring have a problem.
  6. Place a ball on the top of the playfield in the sensor area. The LED should light when the ball rolls over the sensor.